Deutsch
Francais
Italiano
Nederlands
69844T19 one bevel profile, machined
- length 322 mm
- width 100 mm
- thickness 15 mm
- drawing number(s) 69844T19
delivery time (indication)
approximately 3 weeks
| − CXP (most commonly chosen) | CRACOXPLUS (CRACOX480) |
| − S355 | blank structural steel (S355) |
| − CX400 | CRACOX400 |
| − CXE | CRACOXEXTRA (CRACOX520) |
| − CCM0500 | wear-resistant rolled and heat-treated steel, hardness approximately 500 HBr |
exclusive owner of all data and also holder of full copyright of all product images and drawings
CRACO Nederland
Groenoord 424
2401 AP Alphen a/d Rijn
phone call +31 172 423050
e-mail address info@craco.nl
management Jan Hendrik Stougie, Martha Stougie-Donker
Chamber of Commerce number 28077766 KvK Rijnland
VAT-tax identification number NL808035629B01
supplier/manufacturer
CRACO GmbH
Naubergstraße 6
D-57629 Atzelgift
phone call +49 2662 9552 515
e-mail address info@craco.de
management Erich Schönenberg, Stefan Krüger
Chamber of Commerce number Montabaur HRB 1323
VAT-tax identification number DE216637914
transactions
All transactions and agreements regarding the products offered take place between the customer and CRACO GmbH. The owner of this website acts solely as a platform for the presentation of the products and is not responsible for the delivery or transaction terms of the products.
liability for content
Our website is built completely dynamically from a database at the time of invocation. The contents of the database are compiled with the utmost care and are updated almost daily. However, we cannot accept any liability for the correctness, completeness and topicality of the contents. As a service provider, we are responsible for our own content on these pages in accordance with general law. However, as a service provider, we are not obligated to monitor transmitted or stored third-party information or investigate circumstances indicating illegal activity. Obligations to remove or block the use of information in accordance with general law remain unaffected by this. However, liability in this regard is only possible from the moment of knowledge of a specific breach. As soon as we become aware of such infringements, we will immediately remove this content.
responsibility for the links
Our website contains links to external third-party websites over whose content we have no influence. Therefore, we cannot accept any liability for these third-party contents. For the content of the linked pages the respective provider or operator of the pages is always responsible. The linked pages were checked for possible violations of law at the time of linking. Illegal content was not recognizable at the time of linking. However, permanent monitoring of the content of linked pages is not reasonable without concrete evidence of a violation. If we become aware of any violations of law, we will immediately remove such links.
copyright
The content and works created by the site administrators on these pages are subject to copyright. Reproduction, editing, distribution and any form of commercialization of the material outside the scope of copyright law requires prior written permission from CRACO Netherlands or Stougie v.o.f.. Downloads and copies of this site are permitted only for private, non-commercial use. All brand names, type designations and references are for identification purposes only. The "artist impressions "of the machines are only intended to clarify the position of components. If you believe you have observed a third-party copyright infringement, please notify us. If we are informed of infringement, we will immediately remove the relevant content after legal verification.
drawings and images
All drawings and images are made by us for identification purposes. The 3D image is an artistic representation from which no rights can be derived. The 'artist impressions' of the machines are only intended to clarify the position of the components. All brand names, type designations, references and e.g. chosen colour scheme are for identification purposes only.
